Synthesis and Structures of Arene Ruthenium (II)–NHC Complexes: Efficient Catalytic α‐alkylation of ketones via Hydrogen Auto Transfer Reaction

A panel of six new arene Ru (II)‐NHC complexes 2a‐f , (NHC = 1,3‐diethyl‐(5,6‐dimethyl)benzimidazolin‐2‐ylidene 1a , 1,3‐dicyclohexylmethyl‐(5,6‐dimethyl)benzimidazolin‐2‐ylidene 1b and 1,3‐dibenzyl‐(5,6‐dimethyl)benzimidazolin‐2‐ylidene 1c ) were synthesized from the transmetallation reaction of Ag‐NHC with [(η⁶‐arene)RuCl₂]₂ and characterized. The ruthenium (II)‐NHC complexes 2a‐f were developed as effective catalysts for α‐alkylation of ketones and synthesis of bioactive quinoline using primary/amino alcohols as coupling partners respectively. The reactions were performed with 0.5 mol% catalyst load in 8 h under aerobic condition and the maximum yield was up to 96%. Besides, the different alkyl wingtips on NHC and arene moieties were studied to differentiate the catalytic robustness of the complexes in the transformations.     

Carbon Paste Composite with Co3O4 as a New Electrochemical Sensor for the Detection of Allura Red by Reduction

The detection of Allura red (AR) by electrochemical reduction using a different electrode from the conventional mercury electrode is presented. A carbon paste with cobalt (II, III) oxide composite electrode (CoO_x/CPE) is reported for the first time for the detection of AR. Moreover, others dyes such as tartrazine (TZ), sunset yellow (SY), amaranth (AM), Ponceaut 4‐R (P‐4R), and Sudan (SD) as well as pharmaceutical agents such as paracetamol (PMC) that are present in samples that contained AR did not show a reduced signal between 0.0 and ?0.3 V, which is the potential range where AR reduction was observed. The surface electroactivity was studied using cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and scanning electron microscopy (SEM). The presence of CoO_X increased the cathodic peak current for AR by more than 50 % and 65 % via CV and square wave voltammetry (SWV), respectively, compared with an unmodified carbon paste electrode. Under the optimal parameters, (pH=3.0, accumulation time (t_ACC)=60 s and accumulation potential (E_ACC)=0.50 V), the detection limit for AR was 0.05 μmol L^?1. The new sensor was sensitive and stable for the detection of AR. Moreover, it was easily manufactured and very convenient for food samples such as soft and isotonic drinks as well as chili sauce.     

Properties of G-martingales with finite variation and the application to G-Sobolev spaces

As is known, if $B={\left(B_t\right)}_{t\in [0,T]}$ is a $G$-Brownian motion, a process of form ${\int }_0^t{\eta }_{s}d{〈B〉}_s?{\int }_0^{t}2G\left({\eta }_s\right)ds$, $\eta \in M_G^1(0,T)$, is a non-increasing $G$-martingale. In this paper, we shall show that a non-increasing $G$-martingale cannot be form of ${\int }_0^t{\eta }_{s}ds$ or ${\int }_0^t{\gamma }_{s}d{〈B〉}_s$, $\eta ,\gamma \in M_G^1(0,T)$, which implies that the decomposition for generalized $G$-Itô processes is unique: For arbitrary $\zeta \in H_G^1(0,T)$, $\eta \in M_G^1(0,T)$ and non-increasing $G$-martingales $K,L$, if ${\int }_0^t{\zeta }_{s}d{B}_s+{\int }_0^t{\eta }_{s}ds+K_t=L_t,t\in [0,T],$then we have $\eta \equiv 0$, $\zeta \equiv 0$ and$K_t=L_t$. As an application, we give a characterization to the $G$-Sobolev spaces introduced in Peng and Song (2015).     

Development and validation of an ultra‐high‐performance liquid chromatography–tandem mass spectrometry method to determine the bioavailability of warfarin and its major metabolite 7‐hydroxy warfarin in rats dosed with oral formulations containing different polymorphic forms

A simple, sensitive and rapid ultra‐high‐performance liquid chromatography–electrospray ionization–tandem mass spectrometry method was developed and validated for the quantification of warfarin and 7‐hydroxy warfarin in Sprague Dawley (SD) rats. Animals were administered a single dose of warfarin sodium formulations (crystalline and amorphous) at 12 mg/kg via oral gavage and blood was drawn over a 96‐h time course. Sample process recoveries, matrix effect and analyte stability were determined. The linearity for warfarin and 7‐hydroxy warfarin was from 5 to 2000 ng/mL in blank SD rat plasma. Correlation coefficients (r²) for standard calibration curves were >.98 and analytes quantified within ±15% of target at all calibrator concentrations. The average percent accuracy and precision for intra‐ and inter‐day were 93.7%–113.8% and ≤12.1%, respectively, for warfarin and 7‐hydroxy warfarin, across the quality control standards (5, 10, 500, 1800 and 2000 ng/mL). Acceptable analytical recovery (>55%) was achieved with process efficiencies >41.5% and matrix effects <139.9% over the analytical range. Both analytes were stable in stock solution, autosampler, benchtop and three cycles of freeze–thaw with percent accuracy ≥90.2% and precision (percent relative standard deviation) ≤14%. The validated method was successfully applied to a pre‐clinical bioavailability study of crystalline and amorphous warfarin sodium formulations in SD rats.     

On the Discrete Criteria and JØ rgensen Inequalities for SL(m,F((t)))

In this paper, the author gives the discrete criteria and J\o rgensen inequalities of subgroups for the special linear group on $\overline{\mathrm{F}}((t))$ in two and higher dimensions.     

Facile Synthesis of Ultra-Small Few-Layer Nanostructured MoSe2 Embedded on N,P Co-Doped Bio-Carbon for High-Performance Half/Full Sodium-Ion and Potassium-Ion Batteries

Sodium/potassium-ion batteries (SIBs/PIBs) arouse intensive interest on account of the natural abundance of sodium/potassium resources, the competitive cost and appropriate redox potential. Nevertheless, the huge challenge for SIBs/PIBs lies in the scarcity of an anode material with high capacity and stable structure, which are capable of accommodating large-size ions during cycling. Furthermore, using sustainable natural biomass to fabricate electrodes for energy storage applications is a hot topic. Herein, an ultra-small few-layer nanostructured MoSe₂ embedded on N, P co-doped bio-carbon is reported, which is synthesized by using chlorella as the adsorbent and precursor. As a consequence, the MoSe₂/NP-C-2 composite represents exceedingly impressive electrochemical performance for both sodium-ion batteries (SIBs) and potassium-ion batteries (PIBs). It displays a promising reversible capacity (523 mAh g⁻¹ at 100 mA g⁻¹ after 100 cycles) and impressive long-term cycling performance (192 mAh g⁻¹ at 5 A g⁻¹ even after 1000 cycles) in SIBs, which are some of the best properties of MoSe₂-based anode materials for SIBs to date. To further probe the great potential applications, full SIBs pairing the MoSe₂/NP-C-2 composite anode with a Na₃V₂(PO₄)₃ cathode also exhibits a satisfactory capacity of 215 mAh g⁻¹ at 500 mA g⁻¹ after 100 cycles. Moreover, it also delivers a decent reversible capacity of 131 mAh g⁻¹ at 1 A g⁻¹ even after 250 cycles for PIBs.     

Liquid-Repellent Metal Oxide Photocatalysts

Metal oxide photocatalysts (MOPCs) decompose organic molecules under illumination. However, the application of MOPCs in industry and research is currently limited by their intrinsic hydrophilicity because MOPCs can be wetted by most liquids. To achieve liquid repellency, the surface needs to possess a low surface energy, but most organic molecules with low surface energy are degraded by photocatalytic activity. Herein, current methods to achieve liquid repellency on MOPCs, while preventing degradation of hydrophobic coatings, are reviewed. Classically, composite materials containing MOPCs and hydrophobic organic compounds possess good liquid repellency. However, composites normally form irregular coatings and are hard to prepare on surfaces such as those that are mesoporous or nanostructured. In addition, the adhesion of composites to substrates is often weak, resulting in delamination. Recent studies have shown that the direct grafting reaction of polydimethylsiloxane (PDMS) from silicone oil (methyl-terminated PDMS) under illumination results in a stable polymer brush. This easy and simple grafting method allows us to create stable liquid-repellent surfaces on MOPCs of various types, structures, and sizes. In particular, super-liquid-repellent drops with an underlying air layer can be created on PDMS-grafted nano-/microstructured MOPCs. Potential applications of surfaces combining liquid repellency and photocatalytic activity are also discussed; thus offering new ways of using MOPCs in a wider range of applications.